Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 185)

Multi-Service IronWare Switching Configuration Guide 155
53-1003036-02
Deploying a LAG
6
Link The status of the link, which can be up or down.
L2 State The Layer 2 state for the port.
Dupl The duplex state of the port, which can be one of the following:
•
Full
•
Half
•
None
Speed The bandwidth of the interface.
LAG The LAG ID of the port.
Tag Indicates whether the ports have 802.1q VLAN tagging. The value can be Yes
or No.
Priori Indicates the Quality of Service (QoS) priority of the ports. The priority can be a
value from 0 – 7.
MAC The MAC address of the port.
Name The name (if any) configured for the port.
Sys P The system priority configured for the device.
Port P Link aggregation priority of the port
Key Lists the link aggregation key.
Act Indicates the link aggregation mode, which can be one of the following:
•
No – The mode is passive on the port.
If link aggregation is enabled (and the mode is passive), the port can send
and receive LACPDU messages to participate in negotiation of an
aggregate link initiated by another port, but cannot search for a link
aggregation port or initiate negotiation of an aggregate link.
•
Yes – The mode is active. The port can send and receive LACPDU
messages.
Tio Indicates the timeout value of the port. The timeout value can be one of the
following:
•
L – Long. The LAG group has already been formed and the port is
therefore using a longer message timeout for the LACPDU messages
exchanged with the remote port. Typically, these messages are used to
confirm the health of the aggregate link.
•
S – Short. The port has just started the LACPDU message exchange
process with the port at the other end of the link. The S timeout value also
can mean that the link aggregation information received from the remote
port has expired and the ports are starting a new information exchange.
Agg Indicates the link aggregation state of the port. The state can be one of the
following:
•
Agg – Link aggregation is enabled on the port.
•
No – Link aggregation is disabled on the port.
TABLE 27 Show LAG information (Continued)
This field... Displays...