Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 266)

236 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
About IEEE 802.1ad
9
Configuring port type values
Four port-type values are specified. For our example, set 1/10 and 1/11 to provider-network port
type.
Brocade(config)# interface ethernet 1/10
Brocade(config-if-e10000-1/10)# port-type provider-network
Brocade(config-if-e10000-1/10)# exit
Use the following commands to set 1/11 to provider-network port type.
Brocade(config)#interface ethernet 1/11
Brocade(config-if-e10000-1/11)# port-type provider-network
Brocade(config-if-e10000-1/11)# exit
Use the following commands to set 1/1 to customer-edge port type.
Brocade(config)#interface ethernet 1/1
Brocade(config-if-e10000-1/1)# port-type customer-edge
Brocade(config-if-e10000-1/1)# exit
Syntax: [no] port-type [backbone-edge l backbone-network l customer-edge l provider-network]
Use the backbone-edge parameter to specify the backbone edge port for IEEE 802.1ah PBB.
Use the backbone-network parameter to specify the backbone network port for IEEE 802.1ah PBB.
Use the customer-edge parameter to specify the customer edge port for IEEE 802.1ad PB.
Use the provider-network parameter to specify the provider network port IEEE 802.1ad PB.
Displaying the port type
The show interfaces command displays port-type for an interface, as shown below.
Brocade(config-if-e10000-1/2)# show interfaces ethernet 1/10
GigabitEthernet1/10 is up, line protocol is up
STP Root Guard is disabled, STP BPDU Guard is disabled
Hardware is GigabitEthernet, address is 0e04.80de.ada0 (bia 0e04.80de.ada0)
Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx
Member of VLAN 4096 (untagged), port is in untagged mode, port state is Disabled
STP configured to ON, Priority is level0, flow control enabled
arp-inspection-trust configured to OFF
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
Port-type (802.1ad/802.1ah): provider-network
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
NP received 0 packets, Sent to TM 0 packets
NP Ingress dropped 0 packets
0 packets output, 0 bytes, 0 underruns
Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
0 output errors, 0 collisions
NP transmitted 0 packets, Received from TM 0 packets