Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 233)

Multi-Service IronWare Switching Configuration Guide 203
53-1003036-02
IP interface commands
7
eth 12/2 0 0 0 0
p0 0 0 0 0
p7 0 0 0 0
To display the detailed aggregate count of the routed packets and switched packets of a virtual IP
interface are configured combined mode, use the following command.
Brocade# show ip interface ve 10 statistics detail
Extended Routed/Switched Counters (applicable for G2 modules only):
Interface RxPkts TxPkts RxBytes TxBytes
eth 12/1 0 0 0 0
p0 0 0 0 0
p1 0 0 0 0
p6 0 0 0 0
p7 0 0 0 0
Syntax: show ip interface ve vid statistics [detail]
Use the vid option to specify the interface name of the virtual IP interface for which you want to
display the routed and switched packets aggregate count.
TABLE 35 show ip interface ve output details
Clearing IP interface counters
When clearing IP interface counters, the counters that are cleared are dependent on the
accounting mode configuration. If you have configured accounting mode to count routed and
switched packets separately, only the routed counters will be cleared. If you have configured
accounting mode to count routed and switched packets together, the combined counter will be
cleared.
To clear the routed packet and switched packet counters of a specific IP interface, enter the
following command.
Brocade# clear ip interface ethernet 1/2 statistics
Syntax: clear ip interface ethernet port-id statistics
Use the port-id option to specify the interface name to clear.
Clearing IP virtual interface counters
When clearing IP virtual interface counters, the counters that are cleared are dependent on the
Field Description
Interface The interface the counter statistics are displayed.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.