Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 64
34
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying Network Processor statistics
1
NP Rx IPv6 Packet = (0)
NP Rx Route-only Drop = (0)
NP Rx IPv6 Suppress RPF Drop = (0)
NP Rx IPv6 RPF Drop Count = (0)
NP Rx IPv4 Byte = (0)
NP Rx IPv6 Byte = (0)
NP Rx Routed Packet Drop = (0)
Port 10/4 TX
NP Tx Sent to MAC Packet = (1365518)
NP Tx Raw Good Packet = (1365518)
NP Tx Source Port Supress Drop = (0)
NP Tx Bad Packet Count = (0)
NP Tx Unicast Packet = (1324427)
NP Tx Broadcast Packet = (1)
NP Tx Multicast Packet = (41090)
NP Tx IPX HW Forwarded Packet = (41090)
NP Tx Receive from TM = (1365518)
NP Tx ACL Drop = (0)
NP Tx IPv4 Packet = (0)
NP Tx IPv6 Packet = (0)
NP Tx IPv4 Byte = (0)
NP Tx IPv6 Byte = (0)
Syntax: show np statistics [ethernet
You can use the ethernet option and specify a
individual port.
You can use the slot option and specify a
individual interface module.
Output of the Brocade NetIron CES is as follows.
Brocade#show np statistics
TD: Traffic Descriptor. Each TD has size of 512 Bytes
MODULE # 0 PPCR # 0 :
Ingress Counters :
Received packets = 0
Received TDs on traffic class 0 = 0
Received TDs on traffic class 0 = 0
Received TDs on traffic class 1 = 0
Received TDs on traffic class 2 = 0
Received TDs on traffic class 3 = 0
Received TDs on traffic class 4 = 0
Received TDs on traffic class 5 = 0
Received TDs on traffic class 6 = 0
Received TDs on traffic class 7 = 0
Egress Counters :
Transmitted unicast packets = 0
Transmitted multicast packets = 0
Transmitted broadcast packets = 0
Filtered packets due to VLAN spanning tree = 0
Tail dropped packets = 0
Control packets = 0
Packets filtered due to egress forward restrictions = 0)
Syntax: show np statistics [slot