Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 871)

Multi-Service IronWare Switching Configuration Guide 841
53-1003036-02
Displaying IP information
19
Dual Active Console
The Dual Active Console command enables the standby terminal console to mirror the features of
the active console, such that the standby console appears as active console itself. Hence, you can
manage the system from either active or standby console and it will not be necessary to switch the
console cable after the active-standby management module switchover.
To enable this feature, enter the following command,
To disable this feature, enter the following command,
Displaying the IP route table
To display the IP route table, enter the show ip route command at any CLI level.
Syntax: show ip route num | [ip-addr [ip-mask] [debug | detail | longer] ] | connected | bgp | isis
| ospf | rip | static | [ summary ] | nexthop [nexthop_id [ref-routes ] ] | [ begin
expression | exclude expression | include expression ]
The num option display the route table entry whose row number corresponds to the number you
specify. For example, if you want to display the tenth row in the table, enter “10”.
The ip-addr parameter displays the route to the specified IP address.
The ip-mask parameter lets you specify a network mask or, if you prefer CIDR format, the number of
bits in the network mask. If you use CIDR format, enter a forward slash immediately after the IP
address, then enter the number of mask bits (for example: 10.157.22.0/24 for 10.157.22.0
255.255.255.0).
Port The port through which this device reaches the destination. For destinations that are
located on this device, the port number is shown as “n/a”.
VLAN Indicates the VLANs the listed port is in.
Pri The QoS priority of the port or VLAN.
TABLE 106 CLI display of IP forwarding cache (Continued)
This field... Displays...
Brocade(config)#dual-active-console
Brocade(config)#wr mem
Write startup-config done.
Brocade(config)#
Brocade(config)#no dual-active-console
Brocade(config)#wr mem
Write startup-config done.
Brocade(config)#
Brocade# show ip route
Total number of IP routes: 4
Type Codes - B:BGP D:Connected I:ISIS S:Static R:RIP O:OSPF; Cost - Dist/Metric
Destination Gateway Port Cost Type Uptime
1 10.0.0.0/24 DIRECT eth 1/1 0/0 D 45m18s
2 10.10.0.0/24 DIRECT eth 1/2 0/0 D 1h0m
3 10.20.0.0/24 10.0.0.2 eth 1/1 1/1 S 13m18s
4 10.30.0.0/24 10.0.0.2 eth 1/1 1/1 S 2m42s