Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 294)

264 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
ISID mapping to VPLS
10
Syntax: [no] tag-type HEX-VALUE [port-type slot/port [to slot/port]
Use the HEX-VALUE parameter to specify the etype in hex (Default: 0x8100).
Syntax: [no] tag-type isid HEX-VALUE
Use the isid parameter to specify the etype for I-Tagged packets.
Use the HEX-VALUE parameter to specify the etype in hex (Default: 0x88e7).
Topology Groups
For topology groups, the member VPLS VLAN commands have been enhanced to specify the ISID
level. To configure member VPLS VLAN at the ISID level, enter commands such as the following.
Brocade(config)# topo 1
Brocade(config-topo-group-1)# master-vlan 100
Brocade(config-topo-group-1)# member-vlan vpls id 100 vlan 100 isid 450
Syntax: [no] member-vlan vpls id vpls-id | name name vlan vlan-id [to vlan-id] isid isid
OR
Syntax: [no] member-vlan vpls id vpls-id | name name vlan vlan-id [inner-vlan inner-vlan-id [to
inner-vlan-id]… | isid isid]
Show commands
Use the show mpls vplsb id command to display ISID information.
Brocade# show mpls vpls id 3
VPLS name_raw, Id 3, Max macentries: 8192
Total vlans: 1, Tagged ports: 3 (3 Up), Untagged ports 0 (0 Up)
IFL-ID: 4097
Vlan300 inner-vlan500
Tagged: ethe3/1 ethe3/11 ethe3/13
Total VC labels allocated: 16 (983072-983087)
VC-Mode: Raw
Total VPLS peers: 1 (1 Operational)
Peer address: 200.200.200.200, State: Operational, Uptime: 1 hr 10 min
Tnnlin use: tnl1(4)
LDP session: Up, Local VC lbl: 983072, Remote VC lbl: 983072
Local VC MTU: 1500, Remote VC MTU: 1500
LOCAL VC-Type: Ethernet (0x05), Remote VC-Type: Ethernet (0x05)
CPU-Protection: OFF
Local Switching: Enabled