Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 51)

Multi-Service IronWare Switching Configuration Guide 21
53-1003036-02
10G WAN PHY fault and performance management
1
Turning alarm interfaces on and off
When a 10 GbE port is to WAN PHY mode, alarm monitoring is set on by default. You can turn alarm
monitoring off for an individual port as shown in the following.
Brocade(config)# interface ethernet 3/1
Brocade(config-if-e10000-3/1)# no alarm-monitoring
Syntax: [no] alarm-monitoring
Configuring path trace
You can configure a character string to be carried in the SONET overhead as a method of detecting
mis-connection of ports between two devices connected over the WAN PHY. The devices compare
the configured character string with the received character string to determine if the connection is
valid.
You can configure a Brocade device with the character string “test1” using the following command.
Brocade(config)# interface ethernet 3/1
Brocade(config-if-e10000-3/1)# overhead j0-transmit test1
Syntax: [no] overhead [ j0-transmit string ] | [j1-transmit string]
The string variable is the character string used to detect mis-connection of ports it must be
configured with the same value on each side of the WAN PHY connection.
Displaying status of alarms on an interface
You can display the current status of WAN PHY alarms as shown in the following.
Brocade# show control1er curr15min e 3/1
---------------------------------------------------------
10g wan phy alarms statistics - PORT e3/1
---------------------------------------------------------
ACTIVE ALAMRS : LOS
ACTIVE DEFECTS : LOF-S AIS-L AIS-P
Elapsed time [0 min 13 secs]
Format [alarm type = count]
FM-PARAMS
Section
LOS = 1 LOF = 1
Line
AIS-L = 1 RDI-L = 0
Path
AIS-P = 1 LOP = 0 PLM = 0 AIS-PFE = 0 PLM-PFE = 0
PM-PARAMS
Section
CV = 2 ES = 1 SES = 0 SEFS = 0
Line
CV = 3 ES = 1 SES = 0 UAS = 0
CV-FE = 0 ES-FE = 0 SES-FE = 0 UAS-FE = 0
Path
CV = 4 ES = 1 SES = 0 UAS = 0
CV-FE = 0 ES-FE = 0 SES-FE = 0 UAS-FE = 0
Syntax: show controller [ curr15min port no | slot no ] | [ day port no | slot no ] | [ prev15min
interval port no | slot no ]