Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 191)

Multi-Service IronWare Switching Configuration Guide 161
53-1003036-02
Deploying a LAG
6
Displaying the running configuration for a LAG
The show running-config lag command displays the running configuration for a specified LAG or all
LAGs as specified in the parameters.
Brocade# show running-config lag detailed
!
lag "lag1" static id 1
ports ethernet 1/1
ports ethernet 1/2
ports ethernet 1/3
primary-port 1/1
deploy
!
lag "lag2" static id 2
ports ethernet 1/4
primary-port 1/4
Syntax: show running-config lag lag name
The lag name option displays the running configuration for the specified LAG. The lag id option may
also be used to display the same information.
Use the detailed option to display the running-config on a specific lag name or lag id. If no LAG
name or LAG id is specified, the information of the entire LAG configured in the system will be
displayed.
The following command options may be used:
Syntax: show running-config lag
Syntax: show running-config lag detailed
Syntax: show running-config lag detailed lag_id
Syntax: show running-config lag detailed lag name
Syntax: show running-config lag lag_id
Syntax: show running-config lag lag name