Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 164)

134 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Deploying a LAG
5
Ports: e 31/11 to 31/14 e 31/21 to 31/24
Port Count: 8
Primary Port: 31/11
Trunk Type: hash-based
LACP Key: 100
Port Individual Configuration:
Port Name
31/11test
Deployment: Trunk ID 6, Active Primary 31/12, base fid: 0x0800
Port Link Port-State Speed Tag MAC Name
31/11 Up Forward 1G No 00da.1111.27aa test
31/12 Up Forward 1G No 00da.1111.27aa
31/13 Up Forward 1G No 00da.1111.27aa
31/14 Up Forward 1G No 00da.1111.27aa
31/21 Up Forward 1G No 00da.1111.27aa
31/22 Up Forward 1G No 00da.1111.27aa
31/23 Up Forward 1G No 00da.1111.27aa
31/24 Up Forward 1G No 00da.1111.27aa
Syntax: [no] set-lag-port-mode-wid
Table 25 describes the information displayed by the show lag command.
TABLE 25 Show LAG information
This field... Displays...
Total number of LAGS The total number of LAGs that have been configured on the device.
Total number of Deployed
LAGS The total number of LAGs on the device that are currently deployed.
Total number of LAGs
Created The total number of LAGs that have been created on the LAG. The total number of
LAGs available are shown also. Since keep-alive LAGs do not use a LAG ID, they are
not listed and do not subtract for the number of LAGs available.
LACP System Priority /ID The system priority configured for the device.
The ID is the system priority which is the base MAC address of the device.
LACP Long timeout The number of seconds used for the LACP Long timeout mode. This is only
applicable for dynamic or keep-alive LAGs.
LACP Short timeout The number of seconds used for the LACP Short timeout mode. This is only
applicable for dynamic or keep-alive LAGs.
LACP BPDU Forwarding Status of LACP BPDU forwarding on a static LAG:
Disabled– LACP BDPU forwarding is disabled for all ports of the LAG, default
setting.
Enabled– LACP BDPU forwarding is enabled for all ports of the LAG.
The following information is displayed per-LAG in the show lag brief command.
LAG The name of the LAG.
Type The configured type of the LAG: static, dynamic, or keep-alive
Deploy Status of LAG deployment:
Y – yes, LAG is deployed.
N – no, LAG is not deployed.
LAG The LAG ID number.