Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 935)

Multi-Service IronWare Switching Configuration Guide 905
53-1003036-02
sflow null0-sampling
23
sflow null0-sampling
Enables and disables of the null0 sampling.
Syntax [no]sflow null0-sampling
Parameters .slot/port Specifies the port that you want to display nullO sampling for.
Command
Modes
Global configuration mode
Usage
Guidelines
Command
Output
The show sflow command displays the following information:
sFlow services are enabled.
sFlow management VRF is enabled.
sFlow management VRF name is default-vrf.
sFlow agent IP address: 55.55.55.56
sFlow agent IPV6 address: unspecified
sFlow source IP address: unspecified, UDP 8888
sFlow source IPv6 address: unspecified, UDP 8888
Collector IP 77.7.7.2, UDP 6343
Polling interval is 20 seconds.
Configured default sampling rate: 1 per 2048 packets.
0 UDP packets exported
124 sFlow samples collected.
133 sFlow management-vrf UDP packets dropped
0 ACL sFlow samples collected.
sFlow ports Global Sample Rate Port Sample Rate Hardware Sample Rate
1/5 2048 2048 port_down
1/8 2048 2048 2048
sFlow Null-0 Sampling is Enabled.
History
Related
Commands
Release Command History
Multi-Service IronWare R05.5.00 This command was modified to display sFlow
Null-o sampling status.