Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 232)

202 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
IP interface commands
7
TABLE 33 show ip interface command output details
Displaying IP virtual interface counters
To display the counters for each physical port of a virtual IP interface, use the following command.
Brocade#show ip interface ve 10 statistics ethernet 12/1
Extended Routed Counters (applicable for G2 modules only):
Interface RxPkts TxPkts RxBytes TxBytes
eth 12/1 0 0 0 0
p0 0 0 0 0
p1 0 0 0 0
p6 0 0 0 0
p7 0 0 0 0
Syntax: show ip interface ve vid statistics [ethernet port-id]
Specify the port id of the virtual interface for which you want to display.
TABLE 34 show ip interface ve statistics command output details
Displaying detailed IP virtual interface counters
To display the detailed aggregate count of the routed packets and switched packets of a virtual IP
interface are configured separate mode, use the following command.
Brocade# show ip interface ve 10 statistics detail
Extended Routed Counters (applicable for G2 modules only):
Interface RxPkts TxPkts RxBytes TxBytes
eth 12/1 0 0 0 0
p0 0 0 0 0
p1 0 0 0 0
p6 0 0 0 0
p7 0 0 0 0
Field Description
Interface The interface the counter statistics are displayed.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.
Field Description
Interface The interface the counter statistics are displayed.
RxPkts The number of packets received at the specified port.
TxPkts The number of packets transmitted from the specified port.
RxBytes The number of bytes received at the specified port.
TxBytes The number of bytes transmitted from the specified port.