Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 288)

258 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Integrated IEEE 802.1ad and IEEE 802.1ah
10
Use the customer-edge parameter to specify the Customer Edge Port for IEEE 802.1ad PB
Use the provider-network parameter to specify the Provider Network Port IEEE 802.1ad PB
Displaying port- types
The show interfaces command displays port-type for an interface, as shown below.
Brocade(config-if-e10000-5/1)# show interfaces
10GigabitEthernet5/1 is empty, line protocol is down
Hardware is 10GigabitEthernet, address is 0e04.80de.ada0 (bia 0e04.80de.ada0)
Configured speed 10Gbit, actual unknown, configured duplex fdx, actual unknown
Member of VLAN 1 (untagged), port is in untagged mode, port state is Disabled
STP configured to ON, Priority is level0, flow control enabled
arp-inspection-trust configured to OFF
mirror disabled, monitor disabled
Not member of any active trunks
Not member of any configured trunks
Port-type (802.1ad/802.1ah): provider-network
300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 multicasts, 0 unicasts
0 input errors, 0 CRC, 0 frame, 0 ignored
0 runts, 0 giants
NP received 0 packets, Sent to TM 0 packets
NP Ingress dropped 0 packets
0 packets output, 0 bytes, 0 underruns
Transmitted 0 broadcasts, 0 multicasts, 0 unicasts
0 output errors, 0 collisions
NP transmitted 0 packets, Received from TM 0 packets
Syntax: show interfaces
TABLE 43 Display of show interfaces command
This field... Displays...
Module type Port# is State The module type variable specifies a type of interface module, such as
10GigabitEthernet.
The port# variable specifies the port number for the interface module.
The state variable if the interface module is up or down.
Line protocol is status The status variable specifies if the line protocol is up or down.
If the interface is down due to Link Fault Signaling - Remote Fault Notification
(LFS or RFN) the reason is indicated as: “(remote fault)”.
STP Root Guard is status The status variable specifies if the STP Root Guard is enabled or disabled.
STP BPDU Guard is status The status variable specifies if the STP BPDU Guard is enabled or disabled.
Hardware is module type The module type variable specifies a type of interface module, such as
#Gigabit Ethernet.
Address is MAC- address The MAC- address variable specifies the MAC address of the port.
Configured speed and actual
speed The speed that the module has been configured to operate at, and the actual
speed at which it is operating.
Configured port speed and actual
duplex The port capacity that the module has been configured to operate at, and the
actual speed at which it is operating.