Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 650
620
Multi-Service IronWare Switching Configuration Guide
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
1. Create LAG 1 as shown below.
Brocade(config)# lag 1 dynamic id 1
Brocade(config-lag-1)#
2. Define the ports the LAG will be using.
Brocade(config-lag-1)# enable ethernet 1/1 to 1/3
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-1)# primary-port 1/1
4. Deploy the LAG as shown below.
Brocade(config-lag-1)# deploy
5. Assign a name to an individual port within a LAG.
Brocade(config-lag-1)# port-name lag-to-TOR-A ethernet 1/1
Brocade(config-lag-1)# port-name lag-to-TOR-B ethernet 1/3
6. The port can be made inactive (disable) or active (enable) by selecting the appropriate status
option. The default value for a port is disabled. To enable the port on a device for ethernet
interface 1/1, enter the following command.
Brocade(config-if-e10000-1/1)# enable
Configuring Client 2
See
“Creating LAG-1”
for additional information on creating a LAG.
1. Create a LAG with the LAG ID option, enter a command such as the following.
Brocade(config)# lag 1 dynamic id 1
Brocade(config-lag-1)#
2. Define the ports the LAG will be using.
Brocade(config-lag-1)# ports ethernet 1/1 to 1/2
3. The primary port must be explicitly assigned using the primary-port command.
Brocade(config-lag-1)# primary-port 1/1
4. Deploy the LAG as shown below.
Brocade(config-lag-1)# deploy
5. Assign a name to an individual port within a LAG.
Brocade(config-lag-1)# port-name lag-to-TOR-A ethernet 1/1
Brocade(config-lag-1)# port-name lag-to-TOR-B ethernet 1/2
6. The port can be made inactive (disable) or active (enable) by selecting the appropriate status
option. The default value for a port is disabled. To enable the port on a device for ethernet
interface 1/1 and 1/3, enter the following commands.
Brocade(config)# interface ether 1/1
Brocade(config-if-e10000-1/1)# enable
Brocade(config)# interface ether 1/3
Brocade(config-if-e10000-1/3)# enable
7. Assign a name to an individual port within a LAG.
Brocade(config-if-e10000-1/3)# port-name host-to-PC
Brocade(config-if-e10000-1/3)# enable