Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 969)

Multi-Service IronWare Switching Configuration Guide 939
53-1003036-02
show bfd mpls
25
show bfd mpls
A new command show bfd mpls is added to show all MPLS BFD sessions. For BFD session
associated with LSP, the LSP name will be shown. For BFD session associated with egress RSVP
session, the RSVP session ID issued to identify the BFD session. You can filter BFD session based
on LSP name or egress RSVP session ID.
Syntax show bfd mpls [detail|lsp lsp_name|rsvp-session [src_addr/dest_addr/tnnl_addr]]
Parameters detail
The detail option displays the MPLS BFD session in detail.
lsp
The lsp option displays the BFD session associated with a specific LSP specified by the
lsp_name variable.
rsvp-session
The rsvp-session option displays the BFD session associated with the egress RSVP session
specified by the src_addr, dest_addr, or tunnel_addr variable.
Command
modes
This command operate under the mpls sub-configuration mode (config-mpls).
History
Release Command history
Multi-Service NetIron Release 05.6.00 This command was introduced.