Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 980)

950 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying MPLS BFD information
25
Brocade(config)# router mpls
Brocade(config-mpls)# lsp blue
Brocade(config-mpls-lsp-blue)# secondary-path alt_sf_to_sj
Brocade(config-mpls-lsp-blue-sec-path)# bfd
Enabling the IP router alert option
NOTE
The set-router-alert-option command is supported only for NetIron XMR and NetIron MLX devices.
The set-router-alert-option command sets the IP router alert option for MPLS BFD packets sent
from the ingress device to the egress device. Brocade devices support the IP router alert option as
defined in RFC 2113. To enable router alert option, enter the following command under the LSP
BFD configuration.
Brocade(config)# router mpls
Brocade(config-mpls)# lsp blue
Brocade(config-mpls-lsp-blue)# bfd
Brocade(config-mpls-lsp-blue-bfd)#set-router-alert-option
Syntax: [no] set-router-alert-option
By default, the router alert option is disabled.
The router alert option configuration is only displayed when BFD is enabled for LSP. This example
shows the router option enabled for LSP blue.
Displaying MPLS BFD information
You can display the following information about an LSP BFD configuration:
• BFD Application Information
• BFD MPLS Information
• Detailed BFD MPLS Information
• MPLS BFD Global Configuration Information
Brocade(config-mpls-lsp-blue-bfd)#show mpls lsp name blue
LSP blue, to 0.0.0.0
From: (n/a), admin: DOWN, status: DOWN
Times primary LSP goes up since enabled: 0
Metric: 0, number of installed aliases: 0
Maximum retries: 0, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0
Max rate: 0 kbps, mean rate: 0 kbps, max burst: 0 bytes
Constraint-based routing enabled: yes
Tie breaking: random, hop limit: 0
Active Path attributes:
BFD session status: DOWN(LSP down)
Config params: global, min-tx: 50, min-rx: 50, multiplier: 5
Set router alert option: yes