Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 981)

Multi-Service IronWare Switching Configuration Guide 951
53-1003036-02
Displaying MPLS BFD information
25
You can also obtain MPLS BFD information using the show bfd command, as described in
“Displaying BFD information” , and the show mpls lsp command, as described in “Displaying
signalled LSP status information”.
Displaying BFD application information
The following example illustrates the output from the show bfd application command.
Brocade# show bfd application
Registered Protocols Count: 3
Protocol VRFID Parameter HoldoverInterval
isis 0 0 2
ospf6 0 1 10
ospf 0 0 5
This display shows the following information.
Displaying BFD MPLS information
The following example shows output from the show bfd mpls command.
Syntax: show bfd mpls
This display shows the following information.
TABLE 130 Display of BFD application information
This field... Displays...
Protocol Specifies protocols registered to use BFD on the device. Possible values are
mpls/0, ospf/0, ospf6/0, or isis_task/0
VRFID The VRFID of the protocol.
Parameter The parameter value passed by the protocol during registration with BFD.
HoldoverInterval The time by which the BFD session DOWN notification is delayed. If within that
holdover time, the BFD session is UP then it is not notified of the BFD session
flap.
TABLE 131 Display of BFD MPLS information
This field... Displays...
Total number of MPLS BFD
Sessions The number of BFD sessions that have been established on this device.
Session name The name of the session:
For LSP Sessions – the LSP name.
For RSVP Sessions – the session-id which is displayed as IPv4 tunnel
endpoint, tunnel ID, or extended tunnel ID.
Brocade# show bfd mpls
Total number of MPLS BFD sessions: 2
Session name State Interface Holddown Interval RH
lsp1 UP eth 1/2 3000000 1000000 Y
10.11.11.1/1/10.22.22.2 UP eth 1/2 3000000 1000000 Y