Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 239)

Multi-Service IronWare Switching Configuration Guide 209
53-1003036-02
Displaying VLAN information
7
To display information for a specific VLAN, enter a VLAN id as shown in the example below.
Displaying VLAN information for specific ports
To determine which VLANs a port is a member of, enter the following command.
Syntax: show vlan ethernet slot-number/port-number [ | [ begin expression | exclude expression
| include expression]
The ethernet slot-number/port-number parameter specifies a port. The command lists all the VLAN
memberships for the port.
The output shows the following information.
TABLE 37 Output of show vlan Ethernet
This field... Displays...
VLANs The IDs of the VLANs that the port is a member of.
Brocade(config-vlan-13)#show vlan 2001
PORT-VLAN 2001, Name [None], Priority Level 0, Priority Force 0
Topo HW idx : 0 Topo SW idx: 257 Topo next vlan: 0
L2 protocols : MRP
Tagged Ports : ethe 2/1 to 2/6 ethe 2/11 to 2/14 ethe 2/23 to 2/24
Untagged Ports : ethe 1/1 ethe 1/5
Associated Virtual Interface Id: NONE
Brocade# show vlan e 4/1
VLANS 1
VLANs 100