Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 707)

Multi-Service IronWare Switching Configuration Guide 677
53-1003036-02
MCT for VPLS
18
Error: End-point should not be configured while removing Cluster-Peer
configuration.
If any remote peer is configured while resetting the cluster-peer mode for the VPLS instance, the
following error message will be displayed.
Error: Remote-peer should not be configured while removing Cluster-Peer
configuration.
If auto-discover is configured while resetting the cluster-peer mode for the VPLS instance, the
following error message will be displayed.
Error: auto-discovery should not be configured while removing Cluster-Peer
configuration.
VPLS global pw-redundancy (optional)
Once MCT is enabled for a VPLS instance, the two MCT cluster nodes synchronize the configuration
with each other over the CCP and decide which node will take up the Active role and Standby role.
PW redundancy provides is backup PWs ready so that traffic can be quickly failed over to the
backup PWs. This command can be configured either globally for all VPLS Instances with MCT or for
each VPLS instance individually.
NOTE
If it is not configured, the MCT node with lower rbridge-id will be elected as Active to signal to the
remote PE’s.
Use the vpls-pw-redundancy-active command at the global mode to set the pw-redundancy option
for all VPLS Instances with MCT.
Brocade(config-mpls)#vpls-policy
Brocade(config-mpls-vpls-policy)#
vpls-pw-redundancy-active
Syntax: [no] vpls-pw-redundancy-active
The no form of this command removes the pw redundancy option.
Per VPLS instance pw-redundancy (optional)
If vpls-pw-redundancy-active is not configured per VPLS instance, the selection will be based on the
global configuration. The per VPLS Instance configuration always has the higher priority over global
configuration.
Brocade(config-mpls)#vpls test 10
Brocade(config-mpls-vpls-test)#
vpls-pw-redundancy-active
Syntax: [no] vpls-pw-redundancy-active
The no form of this command removes the pw redundancy option.
VPLS show commands
Brocade# show mpls vpls detail
VPLS test, Id 10, Max mac entries: 2048
Total vlans: 0, Tagged ports: 0 (0 Up), Untagged ports 0 (0 Up)