Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 494)

464 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
RSTP support for PB and PBB
13
Port type configuration
Brocade_ES-1(config)#tag-type 9100 eth 1/10
Brocade_ES-1(config)#router mpls
Brocade_ES-1(config-mpls)#vpls pb-svlan 1
Brocade_ES-1(config-mpls-vpls-pb-svlan)#vlan 200
Brocade_ES-1(config-mpls-vpls-pb-svlan-vlan-200)#tag ethernet 1/10
RSTP Configuration
Brocade_ES-1(config-mpls-vpls-pb-svlan#rstp
Use case 7: Core and Edge RSTP
RSTP will run in the PBB core for loop detection and avoidance in the B-VLAN. All ASs and CSs in
B-VLAN will participate in the same RSTP instance. One CS will act as root for the core RSTP
instance. All AS will have a different RSTP instance on the ES facing side and one of the AS will be
acting as a ROOT.
The following deployment scenario is a case where RSTP is deployed for a B-VLAN and S-VLAN in a
PBB network. In CS-1 and CS-2 a regular VLAN 100 is configured as a B-VLAN. AS-1 and AS-2 has a
VPLS VLAN 100 which acts as a B-VLAN. VPLS VLAN 200 on ES-1 and ES-2 which acts as an
S-VLAN for the PB network. CS-1 is configured as the ROOT Bridge for core RSTP. AS-1 and AS-4 are
the ROOT bridges for RSTP on the ES facing side.
The following discussion describes how to configure the nodes in the topology.
FIGURE 104 RSTP deployment in PB and PBB network
Configuring AS-1
NOTE
The configuration of AS-4 is similar to the configuration of AS-1.
Tag type configuration
Configure aport tag type for S-VLAN to 0x9100.
Brocade_AS-1(config)#tag-type 9100 eth 1/1
Brocade_AS-1(config)#tag-type 9100 eth 1/2
CS- 1
AS-3
AS-2
CS-2
ES-2
AS-4
ES-1
AS- 1
Edge RSTP
Edge RSTP
Core RSTP
RSTP-Instance 1
RSTP-Instance 3 RSTP-Instance 2
1/2
1/1 1/1
1/3 1/3
1/1
1/2
1/2
1/3 1/3 1/2 1/5
1/4
1/5
1/4
1/1
1/1
1/4
1/4
1/5
1/5
1/1 (B- VLAN 100)
(S- VLAN 200) (S- VLAN 200)