Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 840)

810 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Configuring IP load sharing
19
To mask the MPLS labels, enter the following command.
Brocade(config)# load-balance mask mpls label0 all
Syntax: [no] load-balance mask mpls [label0 | label1 | label2 | label3] [all | slot-number |
slot-number np-id]
Use the label0 option to mask MPLS Label 0, which is the innermost MPLS label in a packet.
Use the label1 option to mask MPLS Label 1, which is the next innermost MPLS label in a packet
from MPLS Label 2.
Use the label2 option to mask MPLS Label 2, which is the next innermost MPLS label in a packet
with four labels or the outermost MPLS label in a packet with three labels.
Use the label3 option to mask MPLS Label 3, which is the outermost MPLS label in a packet with
four labels.
The all option applies the command to all ports within the router.
Specifying a slot number using the slot-number variable limits the command to an individual
module.
Specifying a slot number and a network processor ID using the slot-number and np-id variables
limits the command to the ports supported by the specified network processor on the specified
interface module.
Displaying MPLS masking information
To display the masking information, enter the following command.
Brocade# show load-balance mask mpls
Mask MPLS options -
Mask MPLS Label0 is enabled on -
No Slots
Mask MPLS Label1 is enabled on -
No Slots