Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 658)

628 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Show commands
Use the show cluster command to display the peer and client states.
Brocade#show cluster
Cluster CLUSTER-1 2000
===================
Rbridge Id: 35535, Session Vlan: 2001, Keep-Alive Vlan: 301
Cluster State: Deploy
Client Isolation Mode: Loose
Configured Member Vlan Range: 2 to 2000 2002 to 4090
Active Member Vlan Range: 2 to 3 21 to 148 201 404 to 445 501 to 508 2010 3511 to
3574 4021 to 4025 4051 4070 4080 4087 4090
ICL Info:
---------
Name Port Trunk
ICL-1 2/1 6
Peer Info:
----------
Peer IP: 1.1.1.1, Peer Rbridge Id: 1, ICL: ICL-1
KeepAlive Interval: 50 , Hold Time: 300, Fast Failover
Active Vlan Range: 2 to 3 21 to 148 201 404 to 445 501 to 508 2010 3511 to 3574
4021 to 4025 4051 4070 4080 4087 4090
Peer State: CCP Up (Up Time: 0 days:19 hr:24 min: 8 sec)
Client Info:
------------
Name Rbridge-id Config Port Trunk FSM-State
Client1 2222 Deployed 1/2 3 Up
Client2 222 Deployed 1/40 - Up
Syntax: show cluster
Use the show cluster client command to display additional State Machine information including the
reason for Local CCEP down.
Brocade#show cluster mct client c2
…
State: Remote Up
Reason for Local CCEP down: "client-interfaces shutdown" command
Number of times Local CCEP down: 2
Number of times Remote CCEP down: 1
Number of times Remote Client undeployed: 1
Total CCRR packets sent: 12
Total CCRR packets received: 13
Syntax: show cluster client
The following reasons are displayed for Local CCEP down.
TABLE 82 Reason for Local CCEP down
Reason for Local CCEP down means....
client-interfaces shutdown command is configured
client-isolation strict command is configured
Deploy mismatch Client is not deployed remotely