Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 872)

842 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Displaying IP information
19
The longer | detail | debug parameter applies only when you specify an IP address and mask. This
option displays only the routes for the specified IP address and mask.
The bgp option displays the BGP4 routes.
The connected option displays only the IP routes that are directly attached to the Brocade device.
The ospf option displays the OSPF routes.
The rip option displays the RIP routes.
The isis option displays the RIP routes.
The static option displays only the static IP routes.
The nexthop option displays next-hop information for all next hops in the routing table or for a
specific entry.
Showing route details by IP address
You can display detailed information about a route by providing the IP address and using the detail
option, as the following example illustrates.
Syntax: show ip route ip_addr detail
The IP address can be just the IP address but can also include shorthand for the mask:
ip-address/prefix-length.
Using the summary option
The summary option displays a summary of the information in the IP route table. After the
summary keyword, the pipe symbol (
| ) points to three options for modifying the presentation of the
summary information, as follows:
• begin lets you start the display with the first matching line.
Brocade>show ip route 10.1.1.2 detail
Type Codes - B:BGP D:Connected I:ISIS O:OSPF R:RIP S:Static; Cost - Dist/Metric
ISIS Codes - L1:Level-1 L2:Level-2
OSPF Codes - i:Inter Area 1:External Type 1 2:External Type 2 s:Sham Link
Destination Gateway Port Cost Type Uptime
1 10.1.1.0/24 DIRECT eth 1/15 0/0 D 7h11m
Nexthop Entry ID:14, Paths: 1, Ref_Count:1/1
1 10.1.1.0/24 10.1.1.2 eth 1/15 115/20 IL2 7h11m
10.1.1.0/24 10.0.0.18 eth 4/11 115/20 IL2 7h11m
10.1.1.0/24 10.0.0.30 eth 4/7 115/20 IL2 7h11m
10.1.1.0/24 10.0.0.34 eth 4/14 115/20 IL2 7h11m
Nexthop Entry ID:68343, Paths: 4, Ref_Count:8/21
D:Dynamic P:Permanent F:Forward U:Us C:Connected Network
W:Wait ARP I:ICMP Deny K:Drop R:Fragment S:Snap Encap N:CamInvalid
Module S1:
IP Address Next Hop MAC Type Port Vlan Pri
10.1.1.0/24 DIRECT 0000.0000.0000 PC n/a 0
OutgoingIf ArpIndex PPCR_ID CamLevel Parent DontAge Index
eth 1/15 65535 1:2 1 0 69203192 38
U_flags Entry_flags Age Cam:Index Trunk_fid Ecmp_count
0000e220 0 0x1a8fc (L3, right) 0x00000( 0) 0
CAM Entry Flag: 00000003H
PPCR : 1:2 CIDX: 0x1a8fc (L3, right) (IP_NETWORK: 0x68703)
PPCR : 1:1 CIDX: 0x1a8fc (L3, right) (IP_NETWORK: 0x68703)