Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 339)

Multi-Service IronWare Switching Configuration Guide 309
53-1003036-02
802.1ag over PBB OAM
11
2. Create a maintenance domain with a specified name CUST_1 and level 7.
Brocade(config-cfm)#domain-name CUST_1 level 7
3. Create a maintenance association within a specified domain for vpls-id 20 with a priority 3.
Brocade(config-cfm-md-CUST_1)#ma-name ma_5 pbb-vpls 20 priority 3
4. Set the time interval between successive Continuity Check Messages (CCM). The default is 10
seconds.
Brocade(config-cfm-md-CUST_1-ma-ma_5)#ccm-interval 10-second
In the above configuration, MIP gets created by default on the VPLS end-points. You can also
configure explicit-mip on PEB-1. In that case, MIP will be created on the VPLS end-points if a MEP is
created on the port at some lower MD Level.
Brocade(config-cfm-md-CUST_1-ma-ma_5)# mip-creation explicit
To change back to default use the following command.
Brocade(config-cfm-md-CUST_1-ma-ma_5)# mip-creation default
Verifying Connectivity Using 802.1ag
Once you configure CE-1, CE-2, PEB-1, and PEB-2 you can determine the end-to-end connectivity by
looking at the remote-mep status using the following show commands:
Syntax: show cfm connectivity [domain NAME] [ma MA NAME]
Brocade#show cfm connectivity
Domain: CUST_1 Level: 7
Maintenance association: ma_5
CCM interval: 10000 ms
VLAN ID: 30
Priority: 3
RMEP MAC VLAN/PEER AGE PORT SLOTS
==== ============= ======= ==== ==== ====
2 000c.dbe2.8a00 30 879 1/2 1
Brocade#show cfm connectivity domain CUST_1 ma ma_5 rmep-id 2
Domain: CUST_1 Level: 7
Maintenance association: ma_5 VLAN ID: 30 Priority: 3
CCM interval: 10
RMEP MAC PORT Oper Age CCM RDI Port Intf Intvl Seq
State Val Cnt Status Status Error Error
==== =============== === === ===== === === ==== ====== ====== ====
2 000c.dbe2.8a00 1/1 OK 26000 2600 N 0 0 N N
Verifying Connectivity Using 802.1ag Loopback/Linktrace
Use the cfm linktrace domain NAME ma MA-NAME src- mep and the cfm loopback domain NAME
ma MA-NAME scr-mep commands to manually monitor the status of peer, as shown below:
Syntax: cfm linktrace domain NAME ma MA-NAME src- mep mep-id target-mip
HH:HH:HH:HH:HH:HH |target-mep mep-id} [timeout timeout] [ttl TTL]
Brocade#cfm linktrace domain CUST_1 ma ma_5 src-mep 1 target-mep 2
Linktrace to 000c.dbe2.8a00 on Domain CUST_1, level 4: timeout 10ms, 8 hops
----------------------------------------------------------------
Hops MAC Ingress Ingress Action Relay Action