Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 893)

Multi-Service IronWare Switching Configuration Guide 863
53-1003036-02
Multiple VLAN Registration Protocol
20
Changing port type to non-default when MVRP is configured over the same port
When a port type of MVRP enabled port is changed to non-default, the following error message is
displayed.
Error: Cannot change port type to non-default when MVRP is enabled on the same
port.
Adding port to VPLS vlan when MVRP is configured over the same port
When an MVRP enabled port is added to a VPLS VLAN, the following error message is displayed.
Error: Please disable mvrp before running %s over any vpls vlan.
Removing single spanning tree instance when MVRP is enabled
When a single STP or RSTP is disabled while MVRP is running, the following error message is
displayed.
Error - single stp cannot be disabled when MVRP is running.
Error - single rstp cannot be disabled when MVRP is running.
When MVRP enabled port is added as secondary port of a trunk
When an MVRP enabled port is added as a secondary port of a trunk, the following error message
is displayed.
Error - mvrp is enabled on secondary port 1/1.
When a VLAN having dynamic ports is removed from base spanning tree
For example, assume statically created VLAN 11 is dynamically learned on port 1/1. Now when
VLAN 11 is removed from the base spanning tree, the following error message is displayed.
Error - Cannot remove spanning tree from VLAN: 11 as it has dynamically tagged
ports.
Syslog Messages
When a VLAN is created dynamically
Jan 9 03:31:42:AM: MVRP: VLAN 100 dynamically added.
When a VLAN is removed dynamically
Jan 9 03:31:42:AM: MVRP: VLAN 100 dynamically removed.
When a VLAN is added on a port dynamically
Jan 9 03:31:42:AM: MVRP: Port 1/2 dynamically added to VLAN 100.
When a VLAN is removed from a port dynamically
Jan 9 03:31:42:AM: MVRP: Port 1/2 dynamically removed from VLAN 100.
When a dynamic Vport changes to static
Jan 9 03:31:42:AM: MVRP: Port VPORT type changed to static for 1/1 and VLAN 100.
When a dynamic VLAN changes to static
Jan 9 03:31:42:AM: MVRP: Dynamic VLAN 100 changed to static.
When VLAN creation threshold is reached
Jan 9 03:31:42:AM: MVRP: System threshold reached for creation of VLANs. MVRP
could not add VLAN 100 on port 1/1.
Logging control
The following command is available to control printing of the MVRP syslog.
Syntax: [no] Logging enable mvrp-vlan