Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 13
Multi-Service IronWare Switching Configuration Guide
xiii
53-1003036-02
Convergence in a simple topology . . . . . . . . . . . . . . . . . . . . . . . . . .423
Convergence at start up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .423
Convergence after a link failure . . . . . . . . . . . . . . . . . . . . . . . .426
Convergence at link restoration . . . . . . . . . . . . . . . . . . . . . . . .427
Convergence in a complex RSTP topology. . . . . . . . . . . . . . . . . . . .428
Propagation of topology change . . . . . . . . . . . . . . . . . . . . . . . .430
Compatibility of RSTP with 802.1D . . . . . . . . . . . . . . . . . . . . . . . . .433
Configuring RSTP parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . .434
RSTP in a LAG. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .434
Enabling or disabling RSTP in a port-based VLAN . . . . . . . . . .435
Enabling or disabling RSTP on a single spanning tree . . . . . .435
Disabling or enabling RSTP on a port. . . . . . . . . . . . . . . . . . . .435
Changing RSTP bridge parameters. . . . . . . . . . . . . . . . . . . . . .435
Changing port parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . .436
Syslogs for RSTP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .437
Displaying RSTP information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .438
Configuring RSTP under an ESI VLAN . . . . . . . . . . . . . . . . . . . . . . .442
RSTP support for PB and PBB . . . . . . . . . . . . . . . . . . . . . . . . . . . . .443
Core RSTP. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .444
Edge RSTP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .444
BPDU behavior on VPLS endpoints. . . . . . . . . . . . . . . . . . . . . .445
Limitations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .445
Configuration commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . .446
Use case scenarios . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .449
Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .467
Metro Ring Protocol (MRP) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 474
MRP rings without shared interfaces (MRP Phase 1) . . . . . . . . . . 476
Ring initialization. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 477
How ring breaks are detected and healed . . . . . . . . . . . . . . . . . . .480
Topology change notification for multicast traffic . . . . . . . . . .483
Master VLANs and member VLANs in a topology group. . . . . . . . .485
Configuring MRP . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .486
Adding an MRP ring to a vlan . . . . . . . . . . . . . . . . . . . . . . . . . .487
Changing the hello and preforwarding times. . . . . . . . . . . . . .488
Changing the scale timer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .488