Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 863)

Multi-Service IronWare Switching Configuration Guide 833
53-1003036-02
Displaying IP information
19
ipv6 address fe80::3:4:2 link-local
ipv6 address 1011::1/64
ipv6 address 1001::1/64
ipv6 ospf area 0
Displaying IP information
You can display the following IP configuration information statistics:
• Global IP parameter settings – refer to “Displaying global IP configuration information” .
• IP interfaces – refer to “Displaying IP interface information” .
• ARP entries – refer to “Displaying ARP entries” .
• Static ARP entries – refer to “Displaying ARP entries” .
• IP forwarding cache – refer to “Displaying the forwarding cache” .
• IP route table – refer to “Displaying the IP route table” .
• IP traffic statistics – refer to “Displaying IP traffic statistics” .
The sections below describe how to display this information.
In addition to the information described below, you can display the following IP information:
• RIP information
• OSPF information
• BGP4 information
• PIM information
Displaying global IP configuration information
To display IP configuration information, enter the following command at any CLI level.
Syntax: show ip
NOTE
This command has additional options, which are explained in other sections in this guide, including
the sections below this one.
This display shows the following information.
Brocade> show ip
Global Settings
IP CAM Mode: dynamic IPVPN CAM Mode: static
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4, icmp-error-rate: 400
IP Router-Id: 10.5.5.5
enabled : UDP-Broadcast-Forwarding ICMP-Redirect Source-Route Load-Sharing
RARP BGP4 OSPF
disabled: Directed-Broadcast-Forwarding drop-arp-pending-packets IRDP Proxy
-ARP RPF-Check RPF-Exclude-Default RIP IS-IS VRRP VRRP-Extended VSRP
Configured Static Routes: 31
Configured Static Mroutes: 30