Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 290)

260 Multi-Service IronWare Switching Configuration Guide
53-1003036-02
Integrated IEEE 802.1ad and IEEE 802.1ah
10
Received value broadcasts, value
multicasts, value unicasts The value variable specifies the amount of traffic the interface module is
receiving on broadcasts, multicasts, and unicast traffic.
value input errors, value CRC,
value frame, value ignored
•
The value variable specifies the number of received packets with errors.
•
The value variable specifies the number of received packets with CRC
errors.
•
The value variable specifies the number of received packets with
alignment errors.
•
The value variable specifies the number of received packets that are
discarded.
value runts, value giants The value runts variable specifies the number of small packets that are less
than 64 bytes.
The value giants variable specifies the number of large packets greater than
1518 bytes.
NP received The number of packets received on the Network Processor (NP).
NP transmitted The number of packets sent from the Network Processor to the Traffic
Manager (TM).
NP Ingress dropped The number of ingress packets dropped on the Network Processor.
value packets output
value bytes
•
The value variable specifies the number of transmitted packets.
•
The value variable specifies the number of transmitted bytes.
Transmitted value broadcasts,
value multicasts, value unicasts The value variable specifies the amount of traffic the interface module
transmitted on broadcasts, multicasts, and unicast traffic.
value output errors, value
collisions
•
The value variable specifies the number of transmitted packets with
errors.
•
The value variable specifies the number of transmitted packets with
collision errors.
Network Processor transmitted
value packets
Received from Traffic Manager
value packets The value variable specifies the number of packets transmitted from the
Network Processor.
The value variable specifies the number of packets received by the Network
Processor from the Traffic Manager.
TABLE 43 Display of show interfaces command
This field... Displays...