Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 137)

Multi-Service IronWare Switching Configuration Guide 107
53-1003036-02
Resetting LLDP statistics
4
LLDP configuration details
The show lldp local-info command displays the local information advertisements (TLVs) that will be
transmitted by the LLDP agent.
NOTE
The show lldp local-info output will vary based on LLDP configuration settings.
The following shows an example report.
A backslash (\) at the end of a line indicates that the text continues on the next line.
The fields in the above output are described in the individual TLV advertisement sections in this
chapter.
Syntax: show lldp local-info [ports ethernet slot num/port num | all]
If you do not specify any ports or use the keyword all, by default, the report will show the local
information advertisements for all ports.
You can list all of the ports individually, use the keyword to to specify ranges of ports, or a
combination of both. To apply the configuration to all ports on the device, use the keyword all
instead of listing the ports individually.
Resetting LLDP statistics
To reset LLDP statistics, enter the clear lldp statistics command at the Global CONFIG level of the
CLI. The Brocade device will clear the global and per-port LLDP neighbor statistics on the device
(refer to
“LLDP statistics” ).
Brocade#clear lldp statistics
Syntax: clear lldp statistics [ports ethernet slot num/port num | all]
Brocade#show lldp local-info ports ethernet 1/40
Local port: 1/40
+ Chassis ID (MAC address): 001b.edb3.f180
+ Port ID (MAC address): 001b.edb3.f1a8
+ Time to live: 40 seconds
+ System name : "CES-151"
+ Port description : "GigabitEthernet1/40"
+ System description : "Brocade NetIron CES, IronWare Version V5.3.0T183 Co\
mpiled on Jan 03 2012 at 18:18:17 labeled as V5.3.0\
0b460"
+ System capabilities : bridge, router
Enabled capabilities: bridge, router
+ 802.3 MAC/PHY : auto-negotiation enabled
Advertised capabilities: 1000BaseX-FD
Operational MAU type : 1000BaseT-FD
+ Link aggregation: aggregated (aggregated port ifIndex: 3)
+ Maximum frame size: 9216 octets
+ Port VLAN ID: 1
+ Management address (IPv4): 10.1.1.151
+ Management address (IPv4): 10.20.103.151
+ Management address (IPv6): 2001:DB8
+ Port-Protocol VLAN ID: not supported