Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 967)

Multi-Service IronWare Switching Configuration Guide 937
53-1003036-02
show bfd
25
Examples
Brocade(config-mpls-bfd)# show bfd
BFD State: ENABLED Version: 1
Current Registered Protocols: mpls/0 isis/0
All Sessions: Current: 4 Maximum Allowed: 250 Maximum Exceeded Count: 0
LP Sessions: Maximum Tx and Rx Allowed on LP: 80 Maximum Exceeded Count for
LPs: 0
LP Tx/Rx Sessions LP Tx/Rx Sessions LP Tx/Rx Sessions LP Tx/Rx Sessions
1 4/4 2 0/0 3 0/0 4 0/0
5 0/0 6 0/0 7 0/0 8 0/0
9 0/0 10 0/0 11 0/0 12 0/0
13 0/0 14 0/0 15 0/0 16 0/0
17 0/0 18 0/0 19 0/0 20 0/0
21 0/0 22 0/0 23 0/0 24 0/0
25 0/0 26 0/0 27 0/0 28 0/0
29 0/0 30 0/0 31 0/0 32 0/0
History
Related
commands
None.
Maximum Exceeded Count for
LPs: The number of times the request to set up a BFD session was declined
because it would have exceeded the maximum number of BFD sessions
allowed on an interface module.
LP The number of the interface modules for which the Current Session
Count is displayed.
Tx/Rx Sessions The number of Transmit (Tx) and Receive (Rx) BFD sessions currently
operating on the specified interface module.
Output field Description
Release Command history
Multi-service NetIron Release 05.6.00 The show bfd command output is extended to include MPLS in the
registered protocol list. In addition, the number of sessions on the LP are
shown separately as TX and RX.