Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 345)

Multi-Service IronWare Switching Configuration Guide 315
53-1003036-02
802.1ag over PBB OAM
11
CFM port (VL800000) PBB-VPLS 100
Brocade#
Syntax: show cfm domain domain-name ma ma-name
Configuring STP under an ESI VLAN
STP can also be configured under a VLAN that is part of a user-configured ESI. For example, to
enable spanning tree on a VLAN that is part of an ESI, configure the following commands.
Brocade(config)# esi customer1 encapsulation cvlan
Brocade(config-esi-customer1)# vlan 100
Brocade(config-esi-customer1-vlan-100)# spanning-tree
Configuration considerations:
The configuration considerations are as follows:
• MSTP can only be configured under the default ESI. MSTP cannot be configured for VLANs that
are configured under a user-defined ESI.
• STP can be configured for VLANs with encapsulation type B-VLAN, S-VLAN or C-VLAN.
When STP or RSTP is configured for VLANs under an ESI, the MRP members must be part of the
same ESI.