Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) - Manual (Page 659)

Multi-Service IronWare Switching Configuration Guide 629
53-1003036-02
About Multi-Chassis Trunk (MCT)
18
Syslogs and debugging
Syslogs are displayed when remote CCEP is state is changed or remote client is deployed or
undeployed.
SYSLOG: Jun 1 15:43:36:<14>Jun 1 15:43:36 CES, CLUSTER FSM: Cluster mct (Id: 1),
client c2 (RBridge Id: 4) -
Remote client deployed
SYSLOG: Jun 1 16:04:24:<14>Jun 1 16:04:24 CES, CLUSTER FSM: Cluster mct (Id: 1),
client c2 (RBridge Id: 4) -
Remote client CCEP up
Sample configuration
The output below is a sample configuration using port loop detection.
Brocade#show run
lag "icl1" dynamic id 1
ports ethernet 3/20 ethernet 4/9
primary-port 3/20
deploy
!
vlan 1 name DEFAULT-VLAN
no untagged ethe 3/20 ethe 4/9
!
vlan 10
tagged ethe 3/20 ethe 4/9
router-interface ve 10
!
vlan 11
untagged ethe 4/17
tagged ethe 3/11 ethe 3/20 ethe 4/9
loop-detection
!
vlan 15
tagged ethe 3/20 ethe 4/9
!
vlan 20
tagged ethe 3/11 ethe 3/20 ethe 4/9 ethe 4/17
!
no route-only
logging console
telnet server
loop-detection-interval 1
loop-detection-disable-duration 1
loop-detection-syslog-duration 11
!
Slave state Client is in Slave State when CCP is down
cluster and client undeployed Neither the Cluster or Client is deployed.
cluster undeployed Cluster is not deployed
client undeployed Client is not deployed
TABLE 82 Reason for Local CCEP down
Reason for Local CCEP down means....