Brocade Multi-Service IronWare Switching Configuration Guide (Supporting R05.6.00) User Manual
Page 865
Multi-Service IronWare Switching Configuration Guide
835
53-1003036-02
Displaying IP information
19
Displaying IP interface information for a specified interface
To display detailed IP information for a specific interface, enter a command such as the following.
NOTE
Interface counters (received packets and received bytes) are not supported on the Brocade NetIron
CES or the Brocade NetIron CER devices. These values will always be 0.
The Brocade device software supports IPv4 and IPv6 packet and byte counters. The contents of
these counters is displayed for a defined port as the result of the show ip interface ethernet
command. In the above example, the fields in bold text display this content.
each of the fields that display interface counter statistics.
Status
The link status of the interface. If you have disabled the interface with the disable
command, the entry in the Status field will be “administratively down”. Otherwise, the
entry in the Status field will be either “up” or “down”.
Protocol
Whether the interface can provide two-way communication. If the IP address is
configured, and the link status of the interface is up, the entry in the protocol field will be
“up”. Otherwise the entry in the protocol field will be “down”.
VRF
Specifies the VRF type applied to the interface.
TABLE 102
Interface counter display statistics
This field...
Displays...
Interface
The interface that counter statistics are being displayed for.
RxPkts
The number of packets received at the specified port.
TxPkts
The number of packets transmitted from the specified port.
RxBytes
The number of bytes received at the specified port.
TxBytes
The number of bytes transmitted from the specified port.
TABLE 101
CLI display of interface IP configuration information (Continued)
This field...
Displays...
Brocade# show ip interface ethernet e 3/1
Interface Ethernet 3/1 (80)
port enabled
port state: UP
ip address: 10.1.1.2/24
Port belongs to VRF: default
encapsulation: ETHERNET, mtu: 1500
MAC Address 0004.80a0.4050
directed-broadcast-forwarding: disabled
No inbound ip access-list is set
No outbound ip access-list is set
No Helper Addresses are configured.
RPF mode: None RPF Log: Disabled
0 unicast RPF drop 0 unicast RPF suppressed drop
RxPkts: 1200 TxPkts: 1200
RxBytes: 60000 TxBytes: 60000