Grass Valley EDIUS Neo 3 - Manual (Page 426)

424 EDIUS NEO — User Reference Guide
Section 5 — Timeline Operations
3. Press the appropriate shortcut key to ripple trim from the beginning of
the clip to the cursor position or from the end of the clip to the cursor
position:
• [ ALT ]+[ N] - ripple trim from the beginning of the clip to the cursor posi-
tion.
• [ ALT ]+[ M ] - ripple trim from the end of the clip to the cursor position. See
Figure 479 for an example of this action.
Figure 479. Ripple Trim from Clip End to Cursor
As illustrated in Figure 479 , since tracks 2VA and 1VA are both selected,
trimming from the end of the clip to the cursor position trims the clips in
both tracks that are at the cursor position.
Note There is a gap between the trimmed clip on track 2VA and the subsequent
clip. The gap is present in order to maintain the relative positions of the clips
following the trimmed clips on both tracks.
Figure 480 depicts the result of trimming from the end of a selected clip to
the cursor position.