Grass Valley EDIUS Neo 3 - Manual (Page 422)

420 EDIUS NEO — User Reference Guide
Section 5 — Timeline Operations
The color of the trim handle on the edit point changes to green or yellow
and trimming is enabled. The yellow trim handle is the active trim handle
at the focussed edit point.
Select the appropriate trim mode button in the Trim window according to
the desired trimming type. See
Table 8 on page 412 for more information on
Trim mode buttons.
The trimming mode changes according to the selected In and Out points.
For more information on trimming modes, see the following references:
• Ripple Trim on page 420
• Split Trim on page 425
• Slide Trim on page 427
• Slip Trim on page 429
• Rolling Trim on page 430
3. Use these shortcuts to trim the clip:
• [ . ] - Trim +1 frame (one frame after the current frame).
• [SHIFT ]+[ . ] - Trim +10 frames (10 frames after the current frame).
• [ , ] - Trim -1 frame (one frame before the current frame).
• [SHIFT ]+[ , ] - Trim -10 frames (ten frames before the current frame).
Ripple Trim
When Ripple mode is On, trimming clips produces the results shown in
this section. For more information on ripple mode, see Ripple Mode
on
page 285 .
1. Click at the beginning (In point) or the end (Out point) of a clip.
The color of the trim handle at the edit point changes to green or yellow as
illustrated in
Figure 476 and trimming is enabled. The yellow trim handle
is the currently-selected trim handle at the edit point.
Note An edit point may also be selected by clicking the Trim - Select IN point or
Trim - Select OUT point buttons in the Trim Window.