Trimming from the preview window – Grass Valley EDIUS Neo 3 User Manual
Page 416
414
EDIUS NEO — User Reference Guide
Section 5 — Timeline Operations
Note
If no edit point(s) are selected, the last-used trimming mode is automatically
selected and edit points are selected based on that mode.
•
When a Timeline clip is selected, the edit point closest to the clicked
point is also automatically selected.
•
When a transition between clips is selected, the In point, Out point or
both may be selected depending upon the clicked position.
•
Edit points are selectable only in combinations allowed by the selected
trimming mode.
•
When a trimming mode is selected, the edit point closest to the Timeline
cursor position is also selected.
Note
If the trimming mode button for the current trimming mode is clicked, the
edit point closest to the Timeline cursor position is reselected.
•
If a transition is the closest edit point to the Timeline cursor, the In
point, Out Point or both may be selected depending upon the relative
positions of the Timeline cursor and the transition.
•
When the Move to Next Edit Point or Move to Previous Edit Point func-
tions are selected, the edit point selection changes in a manner that
maintains the edit point combination for the current trimming mode.
Trimming from the Preview Window
Trimming by dragging the mouse in the Preview window is another avail-
able trimming method. To trim in the Preview window, do the following:
1.
Select Mode>Trimming Mode from the Preview window menu bar as
shown in
.
Figure 468. Trimming Mode Selection
The Preview window switches from normal mode to trim mode.
2.
Click in the In (beginning) point or Out (end) point of a clip to trim.
The color of the trim handle at the edit point changes to green or yellow and
trimming is enabled. The yellow trim handle is the active trim handle.
3.
Select the appropriate trim mode button in the Trim window according
to the desired trimming type. See
information on Trim mode buttons.