Grass Valley EDIUS Neo 3 - Manual (Page 425)

EDIUS NEO — User Reference Guide 423
Trimming Clips
Figure 478. Ripple Mode Trim with Track Ripple Sync On
Note Clips in the same track are linked with Ripple mode on and they move to
maintain their relative positions when clips before them are trimmed. Clips in
other tracks (as long as their In point is after the Out point of the clip being
trimmed) for which Track Ripple Sync is enabled also move to maintain their
position relative to the trimmed clip.
Trimming by Timeline Cursor Position:
1. Click the track(s) where the clip(s) to be trimmed are placed.
Note Clip selection takes precedence over track selection. If clip(s) are selected,
only those clips will be trimmed regardless of track selection status.
2. Move the Timeline Cursor to the point to which the clip(s) should be
trimmed.