Grass Valley EDIUS Neo 3 - Manual (Page 395)

EDIUS NEO — User Reference Guide 393
Timeline Clip Operations
3D Transform Operations
3D transform operations are identical to the 2D transform operation except
that the Position, Anchor and Rotate operation have a Z axis in addition to
X and Y.
Figure 446 shows the 3D transform parameters.
Note Select the 3D button in the Function Tabs and Buttons area to perform 3D
transform operations.
Figure 446. 3D Transform Parameters in the Layouter
Note the three (3) small color circles; green, red and blue. These correspond
to the control points for the Y axis (green), X axis (red) and Z axis (blue).
3D Position
The position of the source image within the frame is controlled by the posi-
tioning controls.
Of course, dragging and dropping the image within the frame is one way
to position an image. Other methods are available in the Position section of
the Parameters tab as illustrated in
Figure 447 .
An image may be repositioned by directly entering the desired X, Y and Z
coordinates of the center of the image, or by using one of the position
control buttons.