Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 75)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 75
Logic Configuration Chapter 4
For the Widg-O-matic example, the path is:
C:\Program Files\RA_Simplification\DMAT\D-Wizard\WidgOmatic\WidgOmatic\Logic.
4. Select the logic xml file and Click Open.
5. From the Revision pull-down menu, choose the version of RSLogix 5000 software, versions 18, 19, or 20,
or the Logix Designer application, version 21 or later, to import into.
6. Click Import to save and open the project as an ACD file.
After the import process is complete, the project opens and the
controller organizer displays all of the preconfigured project
components including the controller, network, device configurations,
the preconfigured logic program files, and the faceplate and control
AOI files.
From this point on, you complete the logic module configuration for
your specific drives and motion application guided by the remaining
sections of this chapter.
To gain a complete understanding of the preconfigured project
organization and logic refer to
Appendix A on page 203 .
IMPORTANT RSLogix 5000 software must be version 19.0 or later. RSLogix 5000 software, version 20.0 or later, is required to configure
Kinetix 350 servo drives and when using ControlLogix 1756-L7xS controllers.