Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 263

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
263
Assemble Project Drawing Set Without the DMAT Wizard
Appendix F
3.
Copy the controller I/O drawings required for your specific application.
For the Widg-O-matic machine application example, all of the 1756 I/O drawings were selected.
4.
Paste the drawings into your Project Drawings folder.
5.
for every unique controller in your system.
For the Widg-O-matic machine application example, the following controller I/O drawings were copied
to accommodate the 1756 ControlLogix controller I/O.
This manual is related to the following products:
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start