Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 284

284
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix G
Controller, Network, and Device Configuration Without the DMAT Wizard
This Module Definition example applies to PowerFlex 700S 2P datalinks.
This Module Definition example applies to the PowerFlex 4-class drives.
IMPORTANT
The PowerFlex 4-class drives do not support datalinks. Therefore, the corresponding PowerFlex 4 faceplates do not require
datalink configuration.
IMPORTANT
For PowerFlex 4-class drive configuration, in addition to checking Use Network Reference, you must also check Use
Network Start to control the drive from the Ethernet network port.
This manual is related to the following products:
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start