Edit power drawings – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 51

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
51
System Layout and Wiring
Chapter 3
Edit Power Drawings
1.
Open your initial drive power drawing that includes the main power distribution components.
For the Widg-O-matic machine application example, the 010_K6500_460VAC_w_LIM.dwg file is
opened. Refer to the figure on
2.
Delete drives not used in your project.
For the Widg-O-matic machine application example, only two Kinetix 6500 drives are required, so the
third drive is deleted. Refer to the shaded area in the figure on
.
3.
Open all additional drive drawings and delete drives not used in your project.
For the Widg-O-matic machine application example, both the
020_K300_460VAC_Additional_Drives.dwg file and the
020_PF750_Series_460VAC_Additional_Drives.dwg file are opened and unused drives are deleted. Refer
to the figures on
and
.
4.
Open all controller control power drawings and edit power connections and devices as necessary.
For the Widg-O-matic machine application example, no changes to the
030_CLX_GLX_120VAC_Control_Power.dwg files were required. Refer to the figure on
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start