Ch6 - system commissioning, Before you begin, What you need – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 147: Chapter 6, System commissioning, Before you begin what you need, Chapter 6 on, Chapter

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
147
Chapter
6
System Commissioning
In this chapter you download your Logix5000 and PanelView Plus applications, prepare and tune your drive
hardware, verify network communications, and verify general operator/program control.
Before You Begin
•
Complete your logic configuration (refer to
•
Complete your FactoryTalk View Machine Edition configuration (refer to
)
What You Need
•
The Drives and Motion Accelerator Toolkit DVD, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative
•
RSLogix 5000 software, version 19.0 or later, or the Logix Designer application, version 21.0 or later.
•
RSLogix 5000 software, version 20.0 or later or the Logix Designer application, version 21.0 or later, to
configure Kinetix 350 servo drives, and when using ControlLogix 1756-L7
xS controllers.
•
FactoryTalk View Studio software, version 5.10 or later
•
The user manual for your Drives and Motion hardware. Refer to
for
publication numbers.
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start