Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 37)

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013 37
Chapter
2
Bill of Materials Completion
In this chapter you use Rockwell Automation ProposalWorks software to complete the drives and motion system
bill of materials that the DMAT Wizard created.
If you chose not to use the DMAT Wizard, follow the procedures in Appendix E to assemble the initial BOM
ProposalWorks file before executing the following steps in this chapter. If you do not have ProposalWorks
software, you may use the Microsoft Excel file that the DMAT Wizard provides as a starting point in creating a
bill of materials with the help of your local Allen-Bradley distributor.
Before You Begin
• Complete the initial system configuration using the DMAT Wizard (refer to Chapter 1 ) or
• Assemble the initial BOM using ProposalWorks software (refer to Appendix E )
What You Need
• The Drives and Motion Accelerator Toolkit DVD, publication IASIMP-SP017 . For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative
• ProposalWorks software, version 7.5 or later, or Microsoft Office Excel 2010
Download ProposalWorks software from
http://www.rockwellautomation.com/en/e-tools/ or ask your
local Allen-Bradley distributor for the Product Selection Toolbox DVD.
• The user manual for your Drives and Motion hardware. Refer to Additional Resources on page 15 for
publication numbers.