Select system communication drawings, Select system, Communication drawings – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 264

264
Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Appendix F
Assemble Project Drawing Set Without the DMAT Wizard
Select System Communication Drawings
1.
Navigate to the desired (DWG, DXF, or PDF) file type folder on the toolkit DVD and select
Communications Section.
2.
Double-click the folder matching your drive communication network.
For the Widg-O-matic machine application example, the Ethernet folder was selected supporting Ethernet
communication on the two Kinetix 6500 servo drives, one PowerFlex 753 drive, and one Kinetix 300 drive.
3.
Copy the communication network
drawing required for your drive
communication.
4.
Paste the drawings into your Project
Drawings folder.
5.
for your HMI and other device communication in your system, if different than your
drive communication network.
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start