Before you begin, What you need, Appendix f – Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start User Manual
Page 255: Before you begin what you need, Appendix

Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
255
Appendix
F
Assemble Project Drawing Set Without the DMAT Wizard
This appendix provides you with the steps necessary to assemble a project drawing set from the toolkit library
without using the DMAT Wizard.
The libraries are organized into power, control, safety, I/O, and communication wiring/panel layout sections.
These steps let you easily assemble all of the wiring and layout drawings for your specific system and minimize
editing of your drawing set.
Before You Begin
Complete your system layout and wiring (refer to
).
What You Need
•
Drives and Motion Accelerator Toolkit DVD, publication
. For a copy of the DVD,
contact your local Rockwell Automation distributor or sales representative.
•
AutoCAD Electrical software to open the DWG or DXF files
•
Adobe Reader software to open PDF files
•
Line Interface Module Installation Instructions, publication
•
System Design for Control of Electrical Noise Reference Manual, publicatio
•
System Design for Control of Electrical Noise Video, publication GMC-SP004
•
The user manual for your Drives and Motion hardware. Refer to Additional Resources on
for
publication numbers.
TIP
If you do not have CAD software that is compatible with the dwg/dxf formats, the pdf files provide an excellent reference library for
wiring all your system devices.
- 150 Drives and Motion Accelerator Toolkit Quick Start 21G Drives and Motion Accelerator Toolkit Quick Start 20G Drives and Motion Accelerator Toolkit Quick Start 20F Drives and Motion Accelerator Toolkit Quick Start 2097 Drives and Motion Accelerator Toolkit Quick Start 2094 Drives and Motion Accelerator Toolkit Quick Start