Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 28)

28 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 1 Initial System Configuration Using the DMAT Wizard
Run the DMAT Wizard
The DMAT Wizard creates an initial bill of materials, assembles a system drawing set, and creates a Logix
Designer project file with preconfigured controller, network, drives, and initial system program logic. All this in
just minutes by executing the following steps.
If you prefer to build these initial files using the traditional application tools, skip over this section and go directly
to
Chapter 2 .
Launch the DMAT Wizard
Follow these steps to launch the DMAT Wizard and set up your wizard configuration.
1. Navigate to and select the DMAT Wizard .exe file on the Drives and Motion Accelerator Toolkit DVD
image.
The DMAT Wizard opens and a dialog box opens, explaining the general scope of the wizard.
2. Read the DMAT Wizard dialog box and click OK to continue wizard configuration.