Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 62)

62 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 3 System Layout and Wiring
3. Add any network device footprints required for your application.
a. Navigate to and open the required footprint drawings that were added to your Project Drawings folder
from the toolkit library.
b. Copy device footprints from the footprint drawings.
In this example, Kinetix 6500 IAM and AM module footprints are copied.
Kinetix 6200/6500 Footprint Drawings
c. Paste the device footprints onto your communication drawing.
d. Re-route or copy cables on the communication drawings to the added devices.
Edit System Layout Drawings
1. Open the panel layout drawing for your application.
For the Widg-O-matic machine application example, the 150_CLX_w_LIM_Sm_Panel_Layout.dwg file
is opened.
The panel layout includes a power distribution, drives, and control section. The panel is designed to
accommodate best-practice techniques used to minimize electrical noise. Refer to the System Design for
Control of Electrical Noise Reference Manual, publication
GMC-RM001 .
Copy this
Kinetix 6500
AM module.
Copy this
Kinetix 6500
IAM module.
FP_2094-B_6500 FP_2094-B_6500 FP_2094-B_6500 FP_2094-BM_6500 FP_2094-BM_6500 FP_2094-BM_6500