Rockwell Automation 193 Drives and Motion Accelerator Toolkit Quick Start - Manual (Page 114)

114 Rockwell Automation Publication IASIMP-QS019E-EN-P - August 2013
Chapter 5 FactoryTalk View ME Configuration
For the Widg-O-Matic example, the parameters are edited as follows:
Widg-O-Matic Parameter File Parameter File Configuration
Gantry_X_Axis
#1=::[CLX]
#2=::[CLX]Gantry_X_Axis_FP
Gantry_Y_Axis
#1=::[CLX]
#2=::[CLX]Gantry_Y_Axis_FP
Conveyor_Drive #1=::[CLX]Conveyor_Drive_FP
Diverter_Drive
#1=::[CLX]
#2=::[CLX]Diverter_Drive_FP
EquipmentStatus
#1=::[CLX]Gantry_X_Axis_FP
#2=::[CLX]Gantry_Y_Axis_FP
#3=::[CLX]Conveyor_Drive_FP
#4=::[CLX]Diverter_Drive_FP
#5=::[CLX]Diverter_Drive_FP
#6=::[CLX]Diverter_Drive_FP
#7=::[CLX]Diverter_Drive_FP
#8=::[CLX]Diverter_Drive_FP
#9=::[CLX]Diverter_Drive_FP
Startup
#1=::[CLX]
#2=::[CLX]WidgOmatic
StateDiagram #1=::[CLX]WidgOmatic
The Equipment Status faceplate requires that
parameters are set for all rows #1…9 even if they
are not visible. Typically, the last visible row
parameter is entered in the remaining
parameters. For example, Diverter_Drive_FP
parameter entered for #4…9.
Refer to Configure Equipment Status Faceplate
Display on
page 138 for more information.