Yaskawa AC Drive-P1000 Industrial Fan - Manual (Page 382)

A
C
NS MS
TX RX
Figure 8.9 Apply the LED Label
Connecting Option and Ground Wire
1.
Insert the option (M) into the CN5-A connector (K) located on the drive and fasten it using one of the included screws
(F).
NS MS
K
L
F
M
TX RX
Figure 8.10 Insert the Option
2.
Connect the ground wire (G) to the ground terminal (H) using one of the remaining provided screws (F). Connect the
other end of the ground wire (G) to the remaining ground terminal and installation hole on the option (M) using the
last remaining provided screw (F) and tighten both screws to 0.5 ~ 0.6 N m or (4.4 ~ 5.3 in lbs).
NS MS
F
G
M
H
TX RX
Figure 8.11 Connect the Ground Wire
Note: There are two screw holes on the drive for use as ground terminals. When connecting three options, two ground wires will need
to share the same drive ground terminal.
8.4 Option Installation
382 YASKAWA SIEP YAIP1U 01B AC Drive - P1000 Technical Manual