Yaskawa MP920 User's Manual Design - Manual (Page 336)

6 System Startup
6.2.1 Installing the Modules
6-6
Use the following procedure to install a Module.
1. Align the two protrusions on the back of the Module with the module mounting holes in
the Mounting Base.
2. Press the Module onto the Mounting Base so that the connector on the back of the Mod-
ule fits into the connector on the Mounting Base.
3. Tighten the top and bottom module mounting screws with a Phillips screwdriver.
This completes the installation procedure.
Module mounting hole (top)
Module mounting hole (botttom)
Mounting Base
Module connector
Module mounting hole (top)
Module mounting hole (botttom)
Mounting Base
Module connector
Use a screwdriver with a blade
length of 10 cm or more.
Module mounting screw
(M4 Phillips screw)